SP VirTis 35L Ultra EL-85°C Stoppering Freeze Dryer with PC and Lyos 2.0
$96.59
Free shipping within 3 days
Easy returns within 30 days
Shopping information security
You Will Receive:
– SP Scientific VirTis 35L Ultra EL-85°C Stoppering Freeze Dryer Lyophilizer (100017375)
– Edwards 15i Dry Scroll Vacuum Pump
– Computer (with Monitor) and LyoS 2.0 Control Software Installed
– Battery Backup
– Communication Cables
– Power Cables for Computer and Peripherals
– Attached Power Cable
– 90-Day Warranty
Notice: This freeze dryer is water cooled. You will need to meet this utility requirement to operate this freeze dryer.
Available Service Upgrades from New Life Scientific:
– 1 Year Extended Warranty
– Annual PM Service Visit: Preventative maintenance involves checking vacuum integrity and instrument calibration
– IQ/OQ Service: Installation Qualification and Operational Qualification Service Visit. This can be a requirement for any company that is producing products that fall under FDA Regulations.
– Acid Trap Installation: Necessary for applications that involve the processing of corrosive materials
Please contact us if you would like to know more about these service upgrades.
Fully Tested and Working Without Issue:
After its initial disinfection and inspection, our technicians tested the SP Scientific VirTis 35L Ultra EL-85°C stoppering freeze dryer with the following results:
– Condenser temperature achieved -85°C (manufacturer’s spec): PASSED
– Shelf temperature achieved -72°C (manufacturer’s spec): PASSED
– Vacuum achieved 5mT: PASSED
15 Shelves Stoppering Shelf Configuration
Shelf size (W x D): 10.8 in x 20.5 in (274.3 mm x 520.7 mm)
Shelf area: 22.96 ft2 (21,331 cm2)
Specifications:
Manufacturer | SP Scientific |
Model | 35L Ultra EL-85° |
Part No. | 100017375 |
Serial No. | 326964 |
Lowest shelf temperature (50Hz / 60Hz) | ≤ -67°C / -70°C |
Shelf temperature control range | -55 to 65°C |
Shelf pull-down from 20°C to -40°C | ≤ 40 minutes |
Lowest condenser temperature (50Hz / 60 Hz) | ≤ -82°C / -85°C |
Maximum condenser capacity | ≥ 35 L |
Condenser surface area | 750 in2 (4,838 cm2) |
Condenser pull-down from 20°C to -45°C | ≤ 25 minutes |
Maximum ice condensing capacity in 24 hours | ≥ 20 L |
Maximum deposition rate | ≥ 0.83 L/hour |
Number of compressors | 2 |
Compressor horsepower | 1.5 hp, 1.5 hp |
Vacuum time to 100 mTorr | ≤ 30 minutes |
Vacuum rate of rise | ≤ 30 mT/hour |
Vacuum control +/- 5 mTorr | 50mTorr to 500mTorr |
Volume-based leak rate | ≤ .0036 mbar L/sec |
Lowest system vacuum | ≤ 15 mT |
Temperature uniformity | ± 1.0°C |
Construction | 316L stainless steel shelves, product chamber and condenser chamber |
Stoppering | Bottom-up hydraulic |
Defrost type | Hot gas |
Refrigerant type | CFC-free |
Vapor port | 8 in (20.3 cm) |
Power rating | 208/230VAC, 60Hz, 50A, 1Ph |
Recommended outlet | NEMA 6-50R |
Overall dimensions (W x D x H) | 50 x 38.75 x 75.75 in |
Minimum clearance | 10 in (25.4 cm) |
Weight | 2,000 lb (909 kg) |
Note: Performance specifications are based on SP test data from units operating at an ambient room temperature of approximately 20°C. SP recommends an optimum operation range of 15-25°C (59-77°F).
Note: SP recommends a 24-inch (61 cm) clearance around all sides of the unit for serviceability. If machines are placed side by side, increase the minimum clearance to 48 inches (121.9 cm)
Utility Requirements:
Water-Cooled | |
Compressed air (for units with isolation valve) | 80 psig (5.5 bar) |
Ambient room temperature | 15-25°C (59-77°F) |
Approx. peak room heat generated | 5,400 BTU/h (1.6 kW) |
Cooling water usage | 2-5 gpm (8-19 Lpm) |
Cooling water load | 17,500 BTU/h (5.1 kW) |
Electrical power rating | 208/230VAC, 60Hz, 50A, 1Ph |
Recommended power outlet | NEMA 6-50R |
Refrigerant Information:
Gas 1 | Gas 2 | |
F gas | R407C | R508B |
Charge (Kg) | 1.245 | 0.970 (AC); 0.452 (WC) |
GWP | 1774 | 13396 |
EPA SNAP | IP/VLTR | IPR/VLTR |
Safety Class | A1 | A1 |
Total CO2e (t) | 15.198 (AC); 8.264 (WC) | 15.198 (AC); 8.264 (WC) |
Reviews
There are no reviews yet.